Florida wind load & product approval screening
Enter a project address and your opening schedule. Get the design pressure required at every opening and which approved products actually clear it — in both directions. Free, unlimited, no signup.
1Project location
Leave blank to use the mapped value. Set it if the jurisdiction has told you otherwise.
2The building
These drive the pressure more than anything else. Defaults describe a typical single-storey house in a built-up neighbourhood.
Houses, trees or similar obstructions in most directions for at least 1,500 ft.
3Opening schedule
Add every opening, or paste the schedule you already have. Dimensions in inches.
1 opening
| Name | Width (in) | Height (in) | Qty | Product type (optional) | |
|---|---|---|---|---|---|
Preliminary screening only. Based on ASCE 7-22 methodology with Florida Building Code county overrides. This is not a stamped engineering calculation and is not for permit submission. Design pressures must be validated by a Florida-licensed professional engineer. Product ratings are best case for the tested configuration — the actual rating depends on glass, reinforcement and, for doors, panel configuration and sill.